Thursday 6 February 2014

CNC Prep

I have used the drawings purchased through theblueprints.com to create a 3d bulk inner core for my Exige bodywork sculpt. The mass has been split up in to 4 pieces lay down ready for cnc cutting. i had to do this within a boundary of 800mm x 400mm an no more that 105mm high. the sections would have been just over 105mm high if i split the car straight down the center so i have had to split it in to 4. these pieces will be cut out of blue foam which will then be stuck together so i can begin sculpting on my bodywork in le beau touche.






No comments:

Post a Comment